Analysis of the electrical circuit of a hybrid electric machine
Analysis of the electric circuit of a hybrid electric machine that functions as a starter and generator. Design, material savings, optimization of the starter mode, generator, starting relay, battery, rectifier units. The process of starting the machine.
| Рубрика | Физика и энергетика |
| Вид | статья |
| Язык | английский |
| Дата добавления | 14.12.2024 |
| Размер файла | 20,1 K |
Отправить свою хорошую работу в базу знаний просто. Используйте форму, расположенную ниже
Студенты, аспиранты, молодые ученые, использующие базу знаний в своей учебе и работе, будут вам очень благодарны.
Размещено на http://www.Allbest.Ru/
Analysis of the electrical circuit of a hybrid electric machine
Khanahmedova S.
Abstract
The article is devoted to the analysis of a hybrid electric machine. A brief analysis of an electric machine performing the functions of a starter and generator is given. Some issues in the design, saving of materials, and optimization of the mode are considered.
Keywords: starter, generator, starting relay, battery, rectifier blocks.
Аннотация
Ханахмедова С. Анализ электрической цепи гибридной электрической машины
Статья посвящена анализу гибридной электрической машины. Дан краткий анализ электрической машины, выполняющей функции стартера и генератора. Рассмотрены некоторые вопросы конструкции, экономии материалов и оптимизации режима.
Ключевые слова: стартер, генератор, пусковое реле, аккумуляторная батарея, выпрямительные блоки.
Introduction
All general-purpose motor vehicles (agricultural, military vehicles and equipment, etc.) have a complex (or less complex) electrical network on their on-board system. The consumers of electric energy included in this system and the generating unit consisting of a battery and a generator are part of this complex. One of the consumers of electric energy is a starter (DC machine) and a generator (AC machine). These electric machines operate in different time intervals. One of the important directions in the field of improvement of electric machines is the combination of the functions of two electric machines in one. In other words, instead of a starter and a generator, use one hybrid electric car.
The developed design of the starter-generator [1, 2], which performs both the function of a starter and a generator, and at the same time environmentally friendly, is based on a low-power DC machine, and despite some change in electrical connections and dual-mode operation, the direct start and start mode of the internal combustion Internal Combustion Engine (ICE).
Analysis of the electrical circuit. The switching of electrical circuits is carried out sequentially taking into account two modes - starter and generator - and these modes should be performed without complications, both with respect to electrical connections and mechanical overloads. Three windings are involved in the conversion of battery electrical energy into mechanical, then mechanical into electrical: armature and two excitation windings - parallel and serial. The anchor winding is used to create a favourable condition when changing the operating range conditions. electric circuit hybrid electric machine
The anchor winding has separate collector plates. The selection of brushes for such a collector is carried out with the calculation of bbr>3ts (bbr - groove width; ts - groove pitch), which is normal for collector machines.
The main excitation winding, which creates the necessary magnetic flux, is powered by a battery; switching on and creating a magnetic flux occurs as in an independent excitation winding, since it turns on before the armature winding turns on (by turning on K1, Fig.1). The electrical diagram shows a sequential excitation winding with several turns, which is designed and calculated for the current of the armature windings.
Considering the mass production of autonomous facilities and the use of nonferrous metals in the production of electrical equipment elements, as well as the increase in electromagnetic loads to the limit in operating electric machines, combining the functions of a starter and a generator and using one machine instead of two will naturally lead to savings of expensive metals. On the other hand, when solving this problem, it becomes possible to increase the rotation speed of this machine in the starter mode. This, in turn, leads to an additional reduction in material consumption [3].
To reduce the volume and weight of the starter generator, it is possible to increase the value of the rotational speed corresponding to the starting speed of the ICE
The selection of the circuit, design and calculation of the armature winding, taking into account the optimal speed of the starter generator, should be carried out for a specific vehicle when designing the complex, taking into account technical and economic indicators.
Fig. 1. Electrical diagram of a hybrid electric machine in starter mode
1 - rechargeable battery; 2 - shunt excitation winding; 3 - anchor winding; 4- sequential excitation winding; K1 - contact for switching on the on-board network to the battery; K2 - starting relay contact
The process of starting a hybrid electric machine, taking into account the above studies, can be analyzed by the following analytical explanations. Considering that the power of the starter generator for the voltage of the on-board network is not small, then when evaluating the mode, it is impossible not to take into account both the electromagnetic and electromechanical flow of processes.
References
1. Musaev Z.N. and Khanahmedova S.A. Starting system operation in the startergenerator // International Journal on “Technical and Physical Problems of Engineering” (ITPE). ISSN 2077-3528, p. 79-83.
2. Musaev Z.N., Khanahmedova S.A. Transition the starter - generator in the generating regime after start of the engine internal combustion // International Journal on Technical and Physical Problems of Engineering TRE- Journal Autumn No1, Vol1, 2009.
3. Khanahmedova S.A. Methods of development of an onboard network of the power system // Problems of power No3, Baku, 2010, page 22-27.
Размещено на Allbest.Ru
...Подобные документы
The properties of conductors of electricity. The electric field is as the forces in the space around a charged body. Diagrams of the electric field and the lines of force in the neighborhoods of charged bodies, the elements of an electrical condenser.
презентация [2,0 M], добавлен 13.01.2012Background to research and investigation of rural electrification. Method of investigation, plan of development, Rampuru, a typical rural South African village. Permanent magnet generator, properties of permanent magnets and evidence of wind resource.
курсовая работа [763,2 K], добавлен 02.09.2010Completing of the equivalent circuit. The permeance of the air-gaps determination. Determination of the steel magnetic potential drops, initial estimate magnetic flux through the air-gap. Results of the computation of electromagnet subcircuit parameters.
курсовая работа [467,8 K], добавлен 04.09.2012Проектирование синхронных генераторов Marathon Electric, состоящих из главного статора и ротора, статора и ротора возбудителя, вращающегося выпрямителя и регулятора напряжения. Характеристики и механический расчет синхронных двигателей серии Magnaplus.
курсовая работа [2,0 M], добавлен 19.09.2012Reducing the noise and vibrations by using hydraulic absorbers as dampers to dissipate the energy of oscillations in railway electric equipments. The phenomenon of the phase synchronization. Examples of stable and unstable regimes of synchronization.
статья [153,4 K], добавлен 25.03.2011The photoelectric effect. The maximum kinetic energy. Putting it all together. Can we use this idea in a circuit. The results of the photoelectric effect allowed us to look at light completely different. The electron microscope. Wave-particle duality.
презентация [2,3 M], добавлен 06.04.2016Study of synthetic properties of magnetic nanoparticles. Investigation of X-ray diffraction and transmission electron microscopy of geometrical parameters and super conducting quantum interference device magnetometry of magnetic characterization.
реферат [857,0 K], добавлен 25.06.2010Determination of wave-length laser during the leadthrough of experiment in laboratory terms by means of diagnostics of laser ray through the unique diffraction of cut. Analysis of results: length of fringe, areas and interrelation between factors.
лабораторная работа [228,4 K], добавлен 29.12.2010Общая характеристика планарных резонаторов на прямых объемных магнитостатических волнах. Особенности и порядок моделирования эквивалентной схемы резонатора на сосредоточенных элементах с помощью компьютерной программы Serenade Design Environment 8.0.
дипломная работа [1,7 M], добавлен 30.08.2010The principles of nonlinear multi-mode coupling. Consider a natural quasi-linear mechanical system with distributed parameters. Parametric approach, the theory of normal forms, according to a method of normal forms. Resonance in multi-frequency systems.
реферат [234,3 K], добавлен 14.02.2010The basic principles and the protection of power lines patterns used in this process methods. Physical basics of high-power transformers in substations. Justification of the information received. Diagram illustrating the operation of the protection.
презентация [628,0 K], добавлен 18.02.2016Machine Translation: The First 40 Years, 1949-1989, in 1990s. Machine Translation Quality. Machine Translation and Internet. Machine and Human Translation. Now it is time to analyze what has happened in the 50 years since machine translation began.
курсовая работа [66,9 K], добавлен 26.05.2005Thermit Welding is not a common process. The process consists of a chemical reaction obtained by igniting finely divided aluminium and iron oxide. The temperature of the molten metal. Electric, spot and flash Welding. Projection Welding Electrodes.
презентация [3,5 M], добавлен 17.12.2009The process of scientific investigation. Contrastive Analysis. Statistical Methods of Analysis. Immediate Constituents Analysis. Distributional Analysis and Co-occurrence. Transformational Analysis. Method of Semantic Differential. Contextual Analysis.
реферат [26,5 K], добавлен 31.07.2008Анализ пакета программ схемотехнического моделирования и проектирования семейства Microcomputer Circuit Analysis Program. Особенности создания чертежа электрической схемы в МС. Общая характеристика и принципы форматов заданий компонентов и переменных.
реферат [581,4 K], добавлен 17.03.2011Изучение внешней и внутренней среды, финансовых подразделений, маркетинговых стратегий американской машиностроительной корпорации General Electric. Бренд и его влияние на поведение фирмы. Стратегические мероприятия в рамках инвестиционного процесса.
реферат [47,2 K], добавлен 31.01.2011Аналіз конкурентної ситуації в міжнародній галузі. Прогнозування кон’юнктури галузі. Дослідження головних напрямків діяльності МНК "Emerson Electric". Фінансовий аналіз компанії. Визначення і прогнозування її корпоративної та конкурентної стратегії.
курсовая работа [1,3 M], добавлен 17.11.2011Характерные технические особенности контроллера ALPHA XL Mitsubishi Electric. Подключение модуля адаптера для получения сигнала с датчиков температуры. Пример разработки в программируемой среде. Преимущества программируемых контроллеров Альфа (alpha xl).
курсовая работа [2,2 M], добавлен 21.06.2013Analysis the machine translation failures, the completeness, accuracy and adequacy translation. Studying the equivalence levels theory, lexical and grammatical transformations. Characteristic of modern, tradition types of poetry and literary translation.
методичка [463,5 K], добавлен 18.01.2012Ознайомлення з поняттям HMI (Human Machine Interface) на прикладі редактора представлення даних системи Trace Mode. Структура та властивості редактора представлення даних для розробки графічної частини проекту системи управління. Типи графічних елементів.
лабораторная работа [1,2 M], добавлен 20.03.2011