Development of a method for increasing the energy efficiency of a household refrigerator by intensifying the process of heat removal from the refrigeration unit with modern fans for blowing the surfaces of the compressor and condenser unit of the device.

Development of a modified computerized system for experimental study of adsorption-desorption processes and defects in ceramics. Using the mathematical data processing positron annihilation spectroscopy. Learning speed capture of positrons by defects.

Identify directions for reforming energy management in support of sustainable development policies in a transition economy. An analysis of the experience of European countries that have gone through the implementation of the concept of energy efficiency.

Analysis of microacceleration as an integral factor of near-Earth space. Classification and features of microaccelerations as an object of study. Selection of the microacceleration component, which can be controlled by optimizing the construction scheme.

Features of plastic forming (micro creep) of a wide class of fresh-quenched metallic glass (mg) at room temperature and under the action of tensile stresses. The increase in the volume fraction of crystallization centers in the amorphous matrix.

Superconducting homopolar motors for ship. Niobium-titanium alloy superconductors. The role by microstructure in determining superconducting properties. Structural aspects of conductivity. Influence by low critical temperature by a superconductors.

A new hydrodynamic theory. The structure formation in deformed materials. Self-consistent non-local formulation of the boundary-value problem for a high-strain-rate process. A penetration for a flat rigid plate into a viscous elastic medium.

Russian experience in the field of non-traditional microwave electronics based on electron beam transverse waves using is discussed in a form of short review. Strictest requirements are placed on a powerful output amplifier and a low-noise input device.

Characteristic features of the effect of noise on the power and polarization characteristics of semiconductor lasers within the scope of our earlier model which considers polarization switching. Research and analysis of results of numerical simulation.

Characteristics of the principle of operation of dynamic model rocket thruster of electromagnetic type consisting of a source of electromagnetic waves of radio frequency and the conical resonator, which are excited by electromagnetic oscillations.

Molecular–statistical model of the organization of the epitropic liquid-crystal phase. The experimental temperature dependences of the thickness of the epitropic liquid crystalline layers nitroben zene on quartz. The thermodynamic model parameters.

An analysis over of character of the isodenses of conical charge products, got by mathematical design. Consideration of character of intermediate initiator using in a downhole charge as the truncated cone at his location in the ground part of hole.

The resulting electromagnetic field is the superposition of electromagnetic fields was found. It was determined the instantaneous electromagnetic force affects the non-ferromagnetic conductive disc and consequently the pressure force of the electrode.

Analysis of physical processes that may cause the fragility and destruction of the lava-like fuel containing materials of 4-th unit of Chernobyl Nuclear Plant. Analysis of influence of electric fields arising in medium with incorporated radionuclides.

Description of models of gas purification from suspended solids in аVenturi scrubber subject to the pulsations of the gas flow. Development of a method of calculating the slip velocity between the fractions of particles including vibrations and movement.

Study of the optical characteristics of the nano-optical structure of the antenna. Need to design the antenna in nano-scale for the visible part of the optical spectrum. The dependence of the enhanced field created by the nanoantenna, on its structure.

The acquaintance with the peculiarities of the spatial distribution of electromagnetic fields. The characteristic features of Electromechanical disintegrator. Consideration of methods of distribution of eddy currents in the working conductive camera EMD.

Molecular dynamics simulations have been performed to study the mechanical properties of two-dimensional titanium carbide under tensile deformation. Young modulus was calculated from the linear part of strain-stress curve. The structure of the samples.

The procedure of coordinating solutions for individual subsystems and does not require iterative calculations by subsystem. Setting the nodes with PMU as slack nodes of subsystems provides coordination of voltage phase angles in subsystem calculations.

Synchronized measurements (the registrations of the transients) of the regime parameters, including vectors of the voltage in the network nodes, creating the technical possibility of realization of the technologies for checking of regime admissibility.

Features of electronic radiation by using the Monte Carlo method in terms of the asymmetry of the protective values of bimetallic dual layer system. The calculation of the dose over protective structure, its application for weight and size protection.

Study of response function of CdZnTe detector to measure the energy spectra of electrons. The calculation of spectra by the Monte Carlo method. The use detector model fitting parameters: products of mobility on the average lifetimes of electrons, holes.

Foundations of radio lenses constructing of centimeter and millimeter wave ranges with controlled refraction index, combining the quality of antennas. Possibilities of the electronically scanning with wide-angle sector and high gain are maintained.

Setting relay protection operate areas and blockings, summarizing settings calculation algorithm. Concept subspace aggregate as real or complex signal. Unconventional approach to data conversion and overcoming opposition of а- and b-conditions.

Моделирование - часть сквозного автоматизированного проектирования. Предложение способа устойчивого совместного моделирования объектов управления и устройств релейной защиты и автоматики при малом времени единичного расчета. Совершенствование алгоритмов.

Повышение энергетической и экономической эффективности использования техногенных отходов. Создание комплекса для переработки древесной биомассы в синтетические жидкие топлива. Получение электроэнергии путем конверсии при сжигании продувочного газа.

Designed optical antenna to increase the interaction area of a local absorber or emitter with free radiation, thereby making the light–matter interaction more efficient. Discussed parameters of aluminum nickel to reduce the cost of gold optical antenna.

Magnetite nanoparticles were synthesized via co-precipitation of iron (II) and iron (III) salts by potassium hydroxide or ammonium hydroxide in aqueous solution. Magnetic properties of magnetite nanoparticles were investigated by magnetometry method.

A theory of electromagnetic wave multiple scattering by ensemble of dielectric and conductive bodies, with describing the excited currents inside bodies of electric field tensor T-scattering operator. A system of equations for currents on surfaces.

Analysis of the potential for cascade failure of the U.S. crude oil pipeline infrastructure using model based risk assessment software. Indentification of regional differences in network resiliency and susceptibility to cascade failure in United States.