Оperating qualities of pin laminate of Cu - Mo used in low-voltage contactors outdoors. Performance of contactors with silver based contacts. Development of recommendations on effective application of such material to replace silver based compositions.

Challenges of biofuel production. The main characteristics of the liquid biofuels production and consumption. Development trends of biofuels production with crop raw material. Economic incentives at different stages of the value chain of liquid biofuels.

Analysis of perspectives of development of renewable energy sources in Poland in the future. Investigation and characterization of the cumulative power installation and electric energy production. Definition of the forecast of power installation.

Structure-phase state, magnetic resistance investigation of Ni/Au/Ni film systems was carried out. Studying dimensional magnetic resistance. It was shown that in Ni/Au/Ni film systems is preferentially presents magnetic resistance in perpendicular pane.

Thermal treatment results in the formation of additional amorphous nanoclusters and in their crystallization with anneal temperature increasing. Nitride films annealed at 1200 °C contain crystalline Si clusters only. Characteristics of SiNx films.

Phase transition for US gauge field is considered. A lower bound of the phase transition temperature by comparing of the average energy for the perturbative and nonperturbative regimes is estimated. In a scalar model of glueball its energy is calculated.

The discovery of giant magnetic seasons granular thin films of alloys - the reason for the study the temperature coefficient of resistance, resistivity. Characteristics of schematic illustration of a single layer and tube current layered structure.

Photocatalytic NaAuCl4 reduction by ethanol with participation of ZnO nanocrystals that results in the formation of gold nanocrystals with the mean size of 25–30 nm. Exceptional capability of gold nanocrystals to accumulate and retain negative charge.

The method of metal-stimulated etching and electrochemical anodic etching were compared. The photoelectric properties of the resulting structure are influenced by the processes of recharging traps. The highly sensitive photodiodes in solar energy.

Intensification of billet deformation for reaching effect of macroshift deformations during stretch forging in combined dies is grounded. Technological modes for approximation work-piece cross-section to round shape and getting resource saving effect.

Evaluation of the effectiveness of the use of piezoelectric technology for the accumulation of energy produced by moving cars. Street lightening using piezoelectric roads. Electricity derived from fossil fuels. Israeli roads using piezoelectricity.

Optical density spectra of amorphous diamond-like films of hydrogenated carbon modified with platinum impurity. The peculiarities of their receipt by the method of ion plasma magnetron joint sputtering of graphite, platinum in argon-hydrogen atmosphere.

The concept of influence of protons on superconductivity and the ideas for determination of superconducting materials with 200K. A superconducting impurity in some layered phases. The study sample with an optimal interlayer electrostatic potential.

Investigation of the post-radiation accumulation of F4 centers in gamma-irradiated LiF crystals after combined (simultaneous or sequential) exposure to moderate heat and a constant electric field. The analysis of the obtained results is carried out.

The energy industry is energy, which includes generation, transmission and distribution of electricity. Thermal power plant is a power plant producing electrical energy by converting chemical energy. Nuclear power plant is a complex of necessary systems.

The efficiency of a thermal power cycle. Use of waste heat for process or central heating. Ways to increase the overall efficiency of the power plant. A combination of different thermodynamic cycles in a combined cycle. Once-through cooling systems.

The analytical expression for the calculation of the relay mode frequency and power. Development of parameters of electric energy converters. The absence of the phase shift between voltage and current. Solution EMC problems. The reduction of power losses.

The conditions to provide the robust stability and control of synchronous machine’s excitation control with magnitude-phase automatic voltage regulator. The structure of MP-AVR with complex input signal. The control law and transfer function of MP-AVR.

In this paper we represent the distinguished laser interferometer technique that allows the wide sort of precise object displacements to be measured with the instrumental resolution up to 1 pm. Indicated the accuracy of reading of the interferometer.

Importance of the different parameters of wearing out of power transformer insulation prediction structure and operating factors. Selection of configuration and parameters of paper insulation and transformer oil technical state models is investigated.

Possible directions to normalize the fuel and energy balance of Ukraine. Necessity of technical upgrade and modernization of allocated boiler installations, as well as reequipment and modernization of power plants industrial sites infrastructure.

Main Objectives of the Project. Alternatives of future. Stages of the Project. Methods and Information Energy in everyday. Main Results of the Project. Dinamics of power engineering. Sectoral and National Critical Technologies for Priority Area.

Among the various sources of alternative energy, wind and solar are two prominent and promising alternatives for future electricity needs. These sources are integrated into distribution networks for local consumers. Adaptive retransmission schemes.

The practice of processing natural gas to pipeline dry gas quality levels. Oil and condensate removal. The actual process used to separate oil from natural gas. Natural gas processing. An example of absorption dehydration is known as Glycol Dehydration.

Features application of shock wave mechanical hardening for the production of micro - or nanocrystalline heterogeneous structures in homogeneous metals or alloys. Analysis of the layering structure and higher productivity of the strengthened element.

Analysis of progress of complexes of local emergency control automation. Hardware and software of modern complexes of ECA. Algorithms of emergency control automation. Digital input/output data used in systems of relay protected and ECA of power industry.

Проектирование сети электроснабжения строительных объектов различного назначения. Основные возможности программы Project StudioCS Электрика 3.0. Объединение модулей системы (освещения и силы). Работа с базами. Формирование набора проектной документации.

Study of heavy and superheavy nuclei. Small sectional synthesis SHN. Analysis of the height of the static fission barriers Bfst of heavy nuclei at the single particle. Determination of the energy of the odd nucleon. Static barrier spontaneous fission.

Areas of application electrodispersion meniscus and the capillary breakup of jets of liquids in a variety of industries with current technology. Education of pulsating microcones. The dynamics of the water meniscus depending on the applied voltage.

Pulsed cathodoluminescence of zinc tungstate samples, doped with europium. Influence of crystal size on the spectral and kinetic parameters of oxygen luminescence within the model of self-organization of the nanodefects in the process of growing crystals.